Installation Manual
Table Of Contents
- AC3100 Installation Guide
- AC3100 Installation
- Mount the AC3100
- Connect the AC3100 to the power source
- Connect the AC3100 to the network
- AC3100 Communication Configuration
- Configure Communication using Front Panel & Service Card
- Configure Communication using RS-232 or Telnet
- AC3100 Transaction Process
- Deposit Funds to an Existing Account
- Purchase a Visitor Card
- Check Account Balance
- AC3100 Manager Card Functions
- Display/print transaction totals
- Terminal setup
- Display device status information
- Perform diagnostic functions
- AC3100 Maintenance
- Fill the Card Dispenser
- Empty the Bill Box
- Install the Paper Roll
- Component Replacement
- Replace the Power Supply Fuses
- AC3100 Features & Specifications
- AC3100 Features:
- AC3100 Specifications:
- BbTS Universal Edition Changes
AC3100 INSTALLATION GUIDE
D OCUMENT 1353 REV 01
PRINTED APRIL 14, 2011 7
Connect the AC3100 to the network
The AC3100 connects to the Universal Edition Host via 10/100 Base-T or RS-485 through an IP Converter
(IPC). In UNIX Edition, the AC3100 optionally connects via the RS-485.
NOTE: When connecting to a Universal Edition Host using RS-485, see: The AC3100 UE
Migration Quick Start Guide for recommended steps.
The network ports are identified on the LCD/PWA cover located on the door. Based on the application, plug
the network cable into the appropriate RJ45 port connection.
NOTE: The RS-485 cable must be terminated with the wiring configuration as shown below.
Figure 1-4 RS-485 Reader Pinout
1
2
3
4
5
6
7
8
RS-485 HOST Port and RJ-45 wall plate wiring
(Ground)
Receive (RX+)
Transmit (TX+)
Receive (RX-)
(Ground)
Transmit (TX-)