Installation Manual
Table Of Contents
- AC3100 Installation Guide
- AC3100 Installation
- Mount the AC3100
- Connect the AC3100 to the power source
- Connect the AC3100 to the network
- AC3100 Communication Configuration
- Configure Communication using Front Panel & Service Card
- Configure Communication using RS-232 or Telnet
- AC3100 Transaction Process
- Deposit Funds to an Existing Account
- Purchase a Visitor Card
- Check Account Balance
- AC3100 Manager Card Functions
- Display/print transaction totals
- Terminal setup
- Display device status information
- Perform diagnostic functions
- AC3100 Maintenance
- Fill the Card Dispenser
- Empty the Bill Box
- Install the Paper Roll
- Component Replacement
- Replace the Power Supply Fuses
- AC3100 Features & Specifications
- AC3100 Features:
- AC3100 Specifications:
- BbTS Universal Edition Changes
AC3100 COMMUNICATION CONFIGURATION
PRINTED APRIL 14, 2011
10
Configure Communication using Front Panel & Service Card
To configure communication using front panel & service card
1 Swipe the specially encoded service card, and then press NEXT.
2 Configure each of the setup parameters, as appropriate, using the keys and display prompts.
ACCEPT - Accept displayed value and advance to next setting.
CHANGE - Change displayed value.
ABORT - Abort configuration process.
To update the IP address and related information, press CHANGE when the parameter displays, and
then type in the number using zeroes (0) as placeholders.
3 Press SAVE when prompted to save the new settings, and then reboot the AC3100.
NOTE: Temporarily Out of Service displays until communication is established with the host.
Figure 1-6 Out-Of-Service Codes
The 'Temporarily Out of Service' screen displays the out-of-service codes in the lower-left portion of
the screen.