Installation Manual

C OMPONENT REPLACEMENT
PRINTED APRIL 14, 2011
20
COMPONENT REPLACEMENT
Replace the Power Supply Fuses
WARNING: To eliminate risk of electrical shock or injury, it is recommended that the main
115VAC supply or breaker be turned off and the power switch on the AC3100 power supply
is turned off!
The AC3100 uses a single 1A 250v fuse for input power and three 3A 250V fuses for output power. The
power input fuse is located directly below the on/off power switch. The output fuses are located across the
bottom of the power supply module. The fuse on the left is for +12v output which supplies power to the
electronics board, LCD, and mag-stripe reader. The center fuse is +24v power for the printer. The right fuse
is +24v power for the bill validator and card dispenser. If a peripheral is not functioning, check the fuse and
replace if necessary.
Figure 1-12 AC3100 Fuse Locations
FIELD REPLACEMENT COMPONENTS
When ordering replaceable parts for the AC3100, refer to the table below and contact Blackboard.
Table 1-4: AC3100 Replacement Parts
MSC Part Number Description
MSC/BVACUS Replacement Bill Validator for United States currency
MSC/BVACCA Replacement Bill Validator for Canadian currency
MSC/RPAC Replacement Printer
MSC/CDAC Replacement Card Dispenser
MSC/RDRAC2 Replacement Contactless/Mag-stripe reader
3AG 3A 250V
3AG 1A 250V
3AG 3A 250V
3AG 3A 250V
Power Supply
CONTROLLER/LCD
& M
AG-STRIPE READER
PRINTER
Bill Validator &
Card Dispenser