Installation Manual
Table Of Contents
- Heading - Vending Reader VR4100 Installation Guide
- Heading1 - Overview
- Heading1 - Reader Installation
- Heading1 - Reader Configuration
- Heading1 - Reader Test
- Heading1 - Reader Audit
- Heading1 - Reader Factory Default Settings
- Heading1 - Reader Specifications
R EADER INSTALLATION
PRINTED O CTOBER 19, 2010
6
9 Route the network cable from the VR4100 out the back of the vending machine.
Typically this should be routed across the door hinge along a cable bundle that already crosses the
door hinge. Use wire ties to hold all wires away from any mechanically moving parts such as hinges,
the coin return lever linkage, door latch, etc.
STOP! DO NOT connect the other end of the network cable to the wall plate until reader
configuration is complete.
10 Power up the vending machine.
This powers up the reader.
Figure 4: Multi-Drop Bus (MDB) Connections
MDB ‘Y’ cable
MDB connector
1
2
3
Configuration
Port
10/100
Network
Connection
MDB
Connection
4