Installation Manual
Table Of Contents
- Heading - Vending Reader VR4100 Installation Guide
- Heading1 - Overview
- Heading1 - Reader Installation
- Heading1 - Reader Configuration
- Heading1 - Reader Test
- Heading1 - Reader Audit
- Heading1 - Reader Factory Default Settings
- Heading1 - Reader Specifications
V ENDING READER VR4100 INSTALLATION GUIDE
D OCUMENT 1277 REV 02
PRINTED O CTOBER 19, 2010 7
READER CONFIGURATION
The VR4100 requires an IP address and Host IP address to communicate with BbTS. If using DHCP, the
reader does not need to be configured. Configure the VR4100 reader using one of three communication
modes:
• Front Panel (Touch Screen & Service Card) Configuration (page 1-7)
• RS-232 Configuration (page 1-8)
•
Web Service Configuration (page 1-9)
Front Panel (Touch Screen & Service Card) Configuration
To configure the reader using Front Panel Configuration
1 Swipe or tap the specially encoded service card.
Figure 5: Configuration Screen
2 Set the configuration parameters using the front panel display.
See: the VR4100 Configuration Flowchart (page 1-16).