Installation Manual
Table Of Contents
- Heading - Vending Reader VR4100 Installation Guide
- Heading1 - Overview
- Heading1 - Reader Installation
- Heading1 - Reader Configuration
- Heading1 - Reader Test
- Heading1 - Reader Audit
- Heading1 - Reader Factory Default Settings
- Heading1 - Reader Specifications
V ENDING READER VR4100 INSTALLATION GUIDE
D OCUMENT 1277 REV 02
PRINTED O CTOBER 19, 2010 11
6 For a wired network, choose Network Wired.
For a wireless network, choose Network Wireless.
Before configuring the reader (wired or wireless mode), ensure that the VR4100 reader is NOT
connected via a CAT5 network port such as a switch.
7 Enter the Network Information.
IP Address
Subnet Mask
Gateway
8 For wireless setup, enter Wireless Configuration.
SSID (the name of the wireless local area network)
Passphrase (must match the wireless access point Passphrase)
9 Enter the Server Configuration information.
10 Click Apply, and then reboot the reader.
S
ETUP READER
Figure 10: Setup Reader Options Window
11 Configure the Reader Setup Options, and then click Apply.