Installation Manual

R EADER TEST
PRINTED O CTOBER 19, 2010
17
READER TEST
To test the reader
1 After configuring the reader, connect the other end of the CAT5 network cable into a 10/100 Base-T
network jack.
If 'Out of Service 100' displays, see the vending machine manufacturer for configuring the
machine to support MDB card readers, or to configure the machine to send cash audit
messages to the card reader.
1 Swipe or tap a card, and then press CANCEL.
Verify the reader returns to the idle display (Please Swipe or tap xxxxxxxxx Card).
2 Insert coins, and then press the coin return lever on the vending machine.
Verify the reader returns to the idle display.
3 Insert money (coins or bills), and then select a product that costs less than the amount inserted.
Verify the reader displays the proper amount and returns to the idle display.
4 Insert money (coins or bills), and then select a product that costs the exact amount inserted.
Verify the reader displays the proper amount and returns to the idle display.
5 Swipe or tap a card, and then select a product that costs less than the maximum credit amount set in
BbTS.
Verify the reader displays the proper amount and returns to the idle display.
6 Swipe or tap a card, and then select a product that costs exactly the maximum credit amount set in
BbTS.
Verify the reader displays the proper amount and returns to the idle display.
7 In BbTS, verify the test transactions posted properly for each test case.