Installation Manual

R EADER FACTORY DEFAULT SETTINGS
PRINTED O CTOBER 19, 2010
20
READER FACTORY DEFAULT SETTINGS
Resetting the reader’s default settings restores the original password. This is established by connecting to
the reader’s CONFIG port, or via web server.
To restore factory default settings using the reader’s CONFIG port
1 Connect a computer to the reader’s CONFIG port, and then unplug the MDB cable from the reader.
Disconnecting the MDB cable powers down the reader.
2 Reconnect the MDB cable, and immediately type a minimum of five ASCII x characters.
Typing ‘xxxxx’ within 3 seconds of the reader boot process will reset to the default settings.
Press the ‘x’ key multiple times, or if the Keyboard Auto-repeat is enabled, hold it down to
accommodate this device’s longer boot time.
To restore factory default settings via web server
1 Open a web browser, and then log into the reader.
See: Web Service Configuration (Page: 9).
2 Choose Admin, and then Reinit Device.
CAUTION!: After a Reinit of the VR4100 Reader with the intention of configuring as wireless
after reboot, ensure that a CAT5 cable is NOT connected to the network.