700 lbs High Lift Telescopic Transmission Jack Operating Instructions & Parts Manual BH7000 SFA Companies ©2005 10939 N. Pomona Ave. Kansas City, MO 64153 816-891-6390 sales@blackhawk-automotive.
ONE YEAR LIMITED WARRANTY For a period of one (1) year from date of purchase, SFA Companies will repair or replace, at its option, without charge, any of its products which fails due to a defect in material or workmanship under normal usage. This limited warranty is a consumer's exclusive remedy. Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, to SFA Companies Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
SAVE THESE INSTRUCTIONS For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of this jack is authorized.
ASSEMBLY Refer to Figure 1 & 2: 1. Attach the base halves (#1) to the upright post (#2), then secure using bolt rods, washers and M12 nuts (#3, 4 & 5) provided. 2. Attach all four casters (#6) to the base halves (#1) using the washers and M12 nuts (#4 & 5) provided. 3. Place hydraulic unit (#7) on top of the upright post (#2) and secure with M10x25 bolts and washers (#8 & 9). 4. Attach saddle assembly (#10) above the ram of hydraulic unit (#7) using pin and spring pin (#11 & 12). 5.
OPERATION Raise saddle: ! WARNING 1. Turn release valve clockwise until firm. Pump handle until load is contacted. 2. Follow vehicle manufacturers recommended procedures for removing the load as outlined in vehicle service manual or repair guide. 3. Secure load with provided chains. Ensure load's center of gravity is centered on the saddle and load is stable before moving jack. To avoid crushing and related injuries: NEVER work on, under or around a load supported only by a jack.
TROUBLESHOOTING Symptom Possible Causes Corrective Action Jack will not lift load • Release valve not tightly closed • Ensure release valve tightly closed • Overload condition • Remedy overload condition Jack bleeds off after lift • Release valve not tightly closed • Ensure release valve tightly closed • Remedy overload condition • Overload condition • Contact Blackhawk Tech.
REPLACEMENT PARTS Not all components of the jack are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence. When ordering parts, give Model number, parts number and description. Call or write for current pricing: SFA Companies 10939 N. Pomona Ave. Kansas City MO 64153, U.S.A. Tel:(816) 891-6390 Fax: (816) 891-6599 E-Mail: sales@blackhawk-automotive.
memo.
