Installation Sheet

BJL 150601

ASSEMBLY & INSTALLATION INSTRUCTIONS for QDR-48P-PC

CAUTION: READ ALL INSTRUCTIONS CAREFULLY FOR SAFE OPERATION AND INSTALLATION.

CAUTION

Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible

shock.

GENERAL

1. All electrical connections must be in accordance with local and national electrical code (N.E.C)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

qualified electrician. Remove the fixture and the mounting package from the box and make sure that

no parts are missing by referencing the illustrations on the installation instruction.

2. Dimming controller type: TRIAC phase control dimmer.

3. Recommended TRIAC dimmers: LEVITON: ILLUMATECH IPL06, SURESLIDE 6674

LUTRON: ARIADNI AYCL-153P, DIVA DVCL-153P, SKYLARK CTCL-153P, SKYLARK SCL-153P

ASSEMBLY AND INSTALLATION

1. Take the fixture out of the box.

2. Remove the back panel (10) from the decorative pan (12) by loosening four decorative nuts (11).

3. Pull the supply wires (2 & 8) and the house ground wire (5) out of the outlet box (1). Temporarily

attach back panel (10) to the outlet box (1) by using two mounting screws (9). Mark the two mounting

hole locations (for anchor screw 13) on the ceiling above the canopy.

4. Remove the back panel (10) from the ceiling. Drill the two holes using the appropriately sized drill

bit. Insert the provided ceiling anchors (14) into the holes. First screw the anchor screws (13) halfway

into the ceiling anchors, then further attach back panel (10) to the outlet box (1) by using two

mounting screws (9). Afterward fully tighten anchor screws (13).

5. Make the wiring connections: connect the white supply wire (8) to the white fixture wire (7);

connect the black supply wire (5) to the black fixture wire (6); connect the house ground wire (2) to the

fixture ground wire (4) using wire connectors (3).

6. Temporarily mount decorative pan (12) to back panel (10) by attaching both loops (16) to mating

hooks (15). Adjust the four suspension cables to appropriate length by either pushing the individual

wire up into the adjustable gripper (17) or pushing the small barrel upward (located on the bottom of

the adjustable gripper). This will release the wire tension and allow the suspended wire to increase in

length.

7. Once the wire is adjusted to approximate mounting length use the attached twist ties to retain the

excess wire into neat loops that will fit inside the decorative pan (12).

PAGE 1
ASSEMBLY & INSTALLATION INSTRUCTIONS for QDR-48P-PC CAUTION: READ ALL INSTRUCTIONS CAREFULLY FOR SAFE OPERATION AND INSTALLATION. CAUTION Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible shock. GENERAL 1. All electrical connections must be in accordance with local and national electrical code (N.E.C) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
PAGE 2
8. Secure the decorative pan (12) to the back panel (10) by tightening four decorative nuts (11). 9. Once the canopy is in place, fine tune the fixture suspension cable lengths to get the fixture level and the four wires even in length. Either push the individual wire up into the adjustable gripper (17) or push the small barrel upward (located on the bottom of the adjustable gripper). This will release the wire tension and allow the suspended wire to increase in length.