User's Manual
10 // USER GUIDE
Charging Loner 900
1. Plug the Wall Charger into an electrical outlet.
2. Insert the Micro USB Cable Plug into the corresponding Micro USB Charging Jack
on the charging clip
3. Slide the charging clip onto Loner 900 using the guides to align the clip with the
charging port on the device.
4. Completely charge Loner 900 for 3 hours.
5. Remove the charging clip from Loner 900.
Charging Loner 900 turns the device O ensuring it will not trigger alerts while charging.
Blackline GPS recommends charging Loner 900 after each shift to ensure the device is
fully charged for the next shift.
WARNING: Never charge Loner in a hazardous area. The Loner’s charger is not intrinsi-
cally safe.
The charging state can be determined by observing the charging light.
Turning Loner 900 On
1. Press the Power Button to turn Loner 900 On.
The beeper, the alarm status light and vibration motor will annunciate the chirp
pattern. The power button indicator light will blink as Loner 900 connects. While
Loner 900 retains connection to Blacklines servers, the power button indicator light
will remain on.
Loner 900 needs to have sucient battery power to connect to the Bridge. Connection
takes approximately one minute.
Light Behaviour Red Charging Light
Light ashing Indicates Loner 900 is charging.
Light On Indicates that Loner 900 is fully charged.
Light O Indicates that Loner 900 is not charging.