User's Manual

SDI Audio De–Embed Table
Analog Audio Channels Switch 6 Switch 5 Switch 4 Switch Diagram
1-2 OFF OFF OFF
3-4 OFF OFF ON
5-6 OFF ON OFF
7-8 OFF ON ON
9-10 ON OFF OFF
11-12 ON OFF ON
13-14 ON ON OFF
15-16 ON ON ON
AES/EBU Audio Channels Switch 6 Switch 5 Switch 4 Switch Diagram
1-4 OFF OFF OFF
5-8 OFF OFF ON
9-12 OFF ON OFF
13-16 OFF ON ON
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings.
You can access these settings by moving between the ‘audio,’ ‘configure,’ and ‘about’ tabs.
The ‘about’ and ‘configure’ tabs are detailed in the ‘changing settings’ section in this manual.
The ‘audio’ tab for Teranex Mini Optical to Audio 12G contains the following settings.
Audio Output Menu
This menu allows you to select between analog, AES/EBU, and timecode audio outputs, as well
as which channels of your SDI or optical audio input you wish to de-embed. You can also adjust
the gain on the audio output.
Your Teranex Mini will retain its last settings whether applied via switch, Smart Panel or Teranex
setup utility. If reverting to switch control after removing the Smart Panel or updating your
converter’s settings via software, you may need to toggle individual switches for new settings to
take effect.
101Teranex Mini – Optical to Audio 12G