User's Manual

9 SDI In
SDI video input BNC connector.
10 SDI Loop Out
SDI video loop output BNC connector.
11 L – Analog or AES/EBU
Balanced left channel analog audio, or digital AES/EBU audio output XLR connector.
12 R – Analog, AES/EBU or Timecode
Balanced right channel analog audio, or digital AES/EBU audio output XLR connector.
Can also be configured for timecode output.
Switches
Teranex Mini – SDI to Analog 12G’s switches provide the following settings:
Switch 8 – Analog Audio, AES/EBU Audio
Set switch 8 to ‘off’ to select balanced analog audio, or to ‘on’ for digital AES/EBU audio output.
Switch 7 – 7.5 IRE, 0.0 IRE
The USA and countries using NTSC with 7.5 setup should set switch 7 to ‘off’. If you’re working
in countries not using 7.5 setup, for example Japan, set switch 7 to ‘on’. This setting only affects
composite or S-Video outputs.
The switch legend on the base of your converter gives you all the
information you need to change conversion settings.
Switch 6 – SMPTE Levels, Betacam Levels
Set switch 6 to ‘off’ for SMPTE levels, or ‘on’ for Betacam levels. SMPTE levels are more
common and even Betacam SP decks can use SMPTE levels, so only switch this to Betacam if
you are sure that Betacam levels are being used.
Switch 5 – Component, Composite or S-Video
Set switch 5 to ‘off’ to select analog component video output, or ‘on’ for composite and
S-Video outputs.
To display the HD video input as SD on the S-Video and composite outputs, down conversion
must be set to ‘on’ by toggling switch 1. Component analog video supports both HD
and SD video.
49Teranex Mini – SDI to Analog 12G