User's Manual

2 Switches
Switches on the front of your Teranex Mini let you change settings using the
tip of a pen.
3 LED Status Indicator
The LED glows white when the converter is receiving power and green when a valid
video input signal is detected. When more than one Teranex Mini is connected to your
computer, you can identify your converter using the ‘identify’ checkbox in Blackmagic
Teranex Setup. When the checkbox is enabled, your converter’s LED will flash
on and off.
4 Power
Standard built in IEC C14 connector for 90 – 240 volt AC power supply.
5 SDI Out A
This BNC connector outputs the following signals:
ͽ SD/HD-SDI
ͽ Single link 3G-SDI
ͽ Single link 6G-SDI
ͽ Dual link HD-SDI channel A
ͽ Dual link 3G-SDI Ultra HD channel A
ͽ Quad link HD-SDI Ultra HD channel A
6 SDI Out B
This SDI video output BNC connector outputs the following signals:
ͽ Dual link HD-SDI channel B
ͽ Dual link 3G-SDI Ultra HD channel B
ͽ Quad link HD-SDI Ultra HD channel B
7 SDI Out C
The ‘SDI Out C’ BNC connector outputs quad link HD-SDI Ultra HD channel C.
8 SDI Out D
This BNC connector is used to output quad link HD-SDI Ultra HD channel D.
9 Ethernet PoE+
The Ethernet connector lets you plug your Teranex Mini into a network switch or
computer so you can change settings using Blackmagic Teranex Setup. The Ethernet
port also supports power over Ethernet plus.
10 12G-SDI In
This input supports a 12G-SDI signal on a BNC connector.
11 SDI Loop Out
This BNC connector outputs the incoming 12G-SDI signal so you can feed it through to
other 12G-SDI equipment.
68Teranex Mini – 12G–SDI to Quad SDI