User's Manual

The switch legend on the base of your converter gives you
all the information you need to change conversion settings.
Switch 6 – 3G Level B/A
This setting lets you change the 3G-SDI output standard to maintain compatibility with
equipment that can only receive level A or level B 3G-SDI video. Level B is the default setting,
and is accessed by setting switch 6 to ‘off.’ To output Level A video, set switch 6 to ‘on.’ These
settings only apply when outputting 3G-SDI video.
Quad Link Selection Table
Quad SDI Output Switch 8 Switch 7 Switch Diagram
Quad HD Split OFF ON
Quad Link OFF OFF
Dual Link ON OFF
Single Link ON ON
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings. You can access these settings by moving between the ‘video,’
‘configure,’ and ‘about’ tabs.
The ‘about’ and ‘configure’ tabs are detailed in the ‘changing settings’ section in this manual.
The ‘video’ tab for Teranex Mini 12G-SDI to Quad SDI contains the following settings.
70Teranex Mini – 12G–SDI to Quad SDI