User Manual

VIEWER 308
These checkboxes must be selected before you perform a track or stabilization operation in order to
restrict the transforms that are used. Once tracking or stabilization has been done, disabling these
checkboxes does nothing to alter the result. To make changes, you need to enable or disable the
necessary checkboxes first, and then re-analyze the clip.
Pan: Enables tracking of horizontal position.
Tilt: Enables tracking of vertical position.
Zoom: Enables tracking of size.
Rotate: Enables tracking of orientation.
Cue To
The Cue To buttons allow you to quickly navigate the playhead to different frames of the current clip
while setting up different tracking operations.
Upper:  Jumpstheplayheadtothefarthestmarktotherightiftwo
marks have been placed.
Lower:  Jumpstheplayheadtothefarthestmarktotheleftiftwomarks
have been placed.
Start:  Jumpstheplayheadtotherstframeofthecurrentclip.
End:  Jumpstheplayheadtothelastframeofthecurrentclip.
Stabilization
These controls are disabled while Tracking Type is set to Window. The Stabilization features are discussed
in a following section.
Controls in the Cue To group