User Manual

CHAPTER
DECK
DECK345
13
Record
The Record tab provides controls to record images from the media storage disks to a video tape deck.
If you have a PowerMaster project it also offers control over the clips to be recorded from the timeline.
Selecttheappropriateclipfromdiskbrowserinthe‘SourceSelection’tab.Thenacquirethedeckby
clickingonthe‘Connect’buttonandpositionthetapetothelocationwhereyouwanttorecordthe
images,clickingonthe‘MarkIn’buttonwithintheTimecodeon Tapesection.Or, simply choose the
appropriate section where to record the material on the tape by typing in a timecode.
Check the Assemble/Insert/Crash setting under the Viewer to make sure it’s as you require. Note: When
DaVinci Resolve is performing a Batch Output operation you can only select between recording the
clips with an Assemble edit or a Crash record. Click on the ‘Record’ button to start the process of
exporting the material to the tape. Once finished, you can check the recording using the transport
controlsorclickonthe‘Connect’buttononceagaintoreleasecontrolofthemachine.Youwillneedto
disconnect prior to exiting the Deck screen.
Clip Information
Within the Clip Information display you will see the timecode for the start and end of the clip, as defined
bytheclip’smetadata.Trimthestartandendpoints;the+and–buttonswilleitheraddorsubtract
frames from the values displayed.
Deck Page Record Tab