User's Manual

Peak
Camera focus can easily be checked by pressing the ‘peak’ button to enable focus peaking.
This displays a bright green edge around the sharpest points in your image. There are two
levels of peaking strengths which you can cycle through with subsequent pressing of the peak
button. When the green edges are at their strongest, you can be sure your camera is in focus.
3D LUT 1 and 3D LUT 2
The LUT buttons let you view your image using custom 3D LUTs generated in Blackmagic
DaVinci Resolve, or industry standard .cube LUTs. Press a LUT button once to enable the LUT.
Press again to disable the LUT. Refer to the ‘loading 3D LUTs using Blackmagic SmartView
setup’ section for more information on using 3D LUTs with SmartView 4K.
H Mark and V Mark
You can view and edit frame markers using the ‘H Mark’ and ‘V Mark’ buttons. Frame markers
help you compose shots or keep important information or graphics within the safe area of the
screen. Different televisions display slightly more or less of the edges of a video signal, so it’s
handy to view a safe area. A safe area is the section of the screen that will always be visible no
matter what television or monitor is being used to view it.
To view horizontal and vertical frame markers, press the H Mark and V Mark buttons
respectively. To edit the markers, press each respective button again to highlight each guide.
This allows you to edit the markers’ positions using the up and down arrow buttons.
Subsequent presses of each button will confirm your new positions. Another press turns the
markers off.
Up and Down Arrow Buttons
Use the up and down arrow buttons when editing a setting, for example adjusting the display
brightness or editing frame marker positions.
Power
Press the power button once to turn your SmartView 4K on. Press again to turn off.
INPUT DISP
H/V
DELAY
3D
LUT 1
BLUE
ONLY
ZOOM PEAK
3D
LUT 2
H
MARK
V
MARK
13Using SmartView 4K