User's Manual

Displaying SD in 16:9
The following command sets standard definition video to display in 16:9:
MONITOR A:
↵
WidescreenSD: ON
↵
Displaying SD in 4:3
The following command sets standard definition video to display in 4:3:
MONITOR A:
↵
WidescreenSD: OFF
↵
Identification and Tally Settings
The Identify flag is transient, and will cause a white border to be displayed around the entire
picture for a duration of 15 seconds, after which it will be reset. This feature is primarily aimed at
identifying which monitor is currently being configured when it is mounted in a rack comprising
multiple units. To turn on:
MONITOR A:
↵
Ide ntify: tr u e
↵
↵
The IDENTIFY border will temporarily override any other border setting in effect.
The BORDER property can be used to programmatically set the soft Tally colored borders to
one of the primary colors: RED, GREEN, BLUE, WHITE or NONE. This setting can be overridden
by the electrical Tally signals at the DB-9 input on the device itself. For example, to set the soft
Tally to green:
MONITOR B:
↵
Border: green
↵
↵
The hard wired tally will always override the soft tally. The full state report will always show the
current valid border.
SmartScope Settings
On SmartScope Duo 4K, each monitor can be set to display a different scope. The values for
activating specific scopes are mapped as follows:
AudioDbfs
AudioDbvu
Histogram
ParadeRGB
ParadeYUV
Picture (This is the same as Video Monitor)
Vector100
Vector75
WaveformLuma
MONITOR A:
↵
ScopeMode: Picture
↵
↵
In the example above, Monitor A has been set as a video monitor.
263
시야각 최적화하기