User's Manual

Using Blackmagic SmartView Setup
Updating the Software
Once Blackmagic SmartView setup is installed and launched, click on the settings icon below
the name of your monitor. You may be prompted to update the internal software of your
SmartView or SmartScope. To do so:
1 Connect your SmartView or SmartScope to the computer via USB or
Ethernet and launch Blackmagic SmartView setup.
2 When prompted, simply click update. The update may take about 5 minutes
to complete.
3 The message: “This SmartView has been updated” should appear upon
completion of the update.
4 Click close.
If no internal software update is required, Blackmagic SmartView setup will open the settings
page for your monitor.
When launching SmartView setup and opening the settings
icon for your connected SmartView or SmartScope, this
message will appear if an internal software update is required
The update will take about 5 minutes to complete
Adjusting Monitor Settings
When launched, Blackmagic SmartView setup will immediately search for any SmartView or
SmartScope units connected via USB or Ethernet and display them in the SmartView setup
home page. If you have more than one Blackmagic monitor connected to your network, click on
the left and right arrow icons on each side of the home page to select the monitor you want to
adjust. If your Blackmagic monitor is connected via USB, a USB icon will appear next to the
monitor name.
8Using Blackmagic SmartView Setup