User's Manual

MODE3D
The MODE3D commands are available in the Teranex 3D only. See the “3D Menu Settings”
section of this user manual for details.
Example:
MODE3D:
↵
3D MODE: 3DModeAlign
↵
↵
ACK
↵
↵
MODE3D:
↵
3D mode: 3DModeAlign
↵
3D roll left: 0
↵
...
↵
A LIGN:
↵
Align size X left: 0.000000
↵
Align size X right: 0.000000
↵
...
↵
Mode, Input and Output Commands
Command Command Description
3D mode: Enable the 3D processing modes of the Teranex 3D.
Valuesare: 3DModeOff, 3DModeConvert, 3DMode2Dto3D,
3DModeAlign
2D3D intensity: Adjust the Intensity level when 3D Mode is set to
2D to 3D. Range is --40 to +40. (Default = 15)
2D3D depth: Adjust the Depth level when 3D Mode is set to
2D to 3D. Range is -12 to +12. (Default = 0)
3D output: Select the 3D output signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
3D input: Select the 3D input signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
Rotation and Tilt Commands
The commands below may be used to adjust the alignment between the left and right eye
signals of a 3D stereoscopic source. In the Teranex 3D LCD menus, these functions are part of
the “Camera Align” menu.
Rotation (Roll, Tilt and Toe-in) and Flip commands are included in this block. Other Camera Align
functions, Size, Position and Trim, are found in the Align block.
First, enter the “MODE3D:” block command, then use the “3D mode:” command to select
“3DModeAlign” and proceed with the adjustment commands below.
Example:
MODE3D:
↵
3D roll left: 20
↵
↵
111111Developer Information