User's Manual

ACK
↵
↵
MODE3D:
↵
3D roll left: 20
↵
3D roll right: 0
↵
↵
Command Command Description
3D roll left: Adjust the Left Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
3D roll right: Adjust the Right Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
3D tilt left: Adjust the Left Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
3D tilt right: Adjust the Right Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
3D toeIn left: Adjust the Left Eye Y axis image toe-in.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
3D toeIn right: Adjust the Right Eye Y axis image toe-in.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
3D flip left: Flip the Left Eye image. Values are:
Off, Horizontal, Vertical, Both
3D flip right: Flip the Right Eye image. Values are:
Off, Horizontal, Vertical, Both
Network Config
Command Command Description
Friendly name: Displays the current user-defined name assigned
to the device. Command is used to assign a new
nametothe device.
DHCP enabled: Although not advised, user may enable/disable
DHCP.True = enabled; False = disabled
IP address: Displays current IP address as an integer.
Cannot be changed by the user.
Gateway: Displays current gatewayas an integer.
Cannot be changed by the user.
Subnet: Displays current subnet maskas an integer.
Cannot be changed by the user.
112112Developer Information