Instruction manual

Third Party Applications
32
Batch Capture
Select the clips you wish to capture by drag selecting or shift-clicking each clip. Then choose:
File > Batch Capture [F6]. To set handles on the clips, enable the option to Capture with handles
and type the number of additional frames you require at the start and end of each clip.
Export to Tape
To export to tape, select the sequence you require and then choose
File > Export > Tape
Insert editing requires unbroken timecode over the full length of the project which is to be laid to tape. The
process of creating unbroken timecode is referred to as “blacking the tape”.
In assemble mode the tape needs only to be “blacked” until a point just beyond the start time of the
project. As assemble editing erases the tape ahead of the record heads, it should not be used where other
projects already exist on the tape after the out point of your edit.
When editing to tape, the software waits at the first frame of your project for the deck to drop into record
at the predetermined timecode. At that exact moment, the software begins to play until the edit is
completed. Should you find that either the first frame of your program is repeated or lost, during the edit
to tape procedure, you will need to adjust the playback offset to bring the deck and computer in sync.
You should only need to do this once with any combination of deck and computer and the correct setting
will be retained.
Now, simply enter the desired in point and offsets if required, and click
OK.
Export to Tape