Instructions / Assembly

7
! !
DANGER
• NEVER store a spare LP cylinder under or near the
appliance or in an enclosed area.
• Never ll a cylinder beyond 80% full.
• If the information in the two points above is not fol-
lowed exactly, a re causing death or serious injury
may occur.
• An overlled or improperly stored cylinder is a
hazard due to possible gas release from the safety
relief valve. This could cause an intense re with
risk of property damage, serious injury or death.
• If you see, smell or hear gas escaping,
immediately get away from the LP cylinder and
appliance and call your re department.
LP Tank Removal, Transport And Storage
• Turn OFF all control knobs and LP tank valve. Turn
coupling nut counterclockwise by hand
only - do not use tools to disconnect. Lift LP tank
wire upward off of LP tank collar, then lift LP tank up.
Install safety cap onto LP tank valve. Always use cap
and strap supplied with valve.
Failure to use safety cap as directed may result in
serious personal injury and/or property damage.
• A disconnected LP tank in storage or being
transported must have a safety cap installed (as
shown). Do not store an LP tank in enclosed spaces
such as a carport, garage, porch, covered patio or
other building. Never leave an LP tank inside a
vehicle which may become overheated by the sun.
• Do not store an LP tank in an area where
children play.
LP Tank
The LP Tank used with your grill must meet the
following requirements:
• LP Tanks must be constructed and marked in
accordance with specications for LP Tanks of the
U.S. Department of Transportation (DOT) or for
Canada, CAN/CSA-B339, 20 lb tanks (LP tank di-
mension: 12.3 inches wide x 18 inches tall), spheres
and tubes for transportation of dangerous goods.
Transport Canada (TC).
See LP Tank collar for marking.
LP Tank valve must have:
• Type 1 outlet compatible with regu-
lator or grill.
• Safety relief valve.
• UL listed Overll Protection Device
(OPD). This OPD safety feature is identied by a
unique triangular hand wheel. Use only LP Tanks
equipped with this type of valve.
LP Tank must be arranged for vapor withdrawal and
include collar to protect LP Tank valve. Always keep LP
Tanks in upright position during use, transit or storage.
LP Tank in upright position for vapor withdrawal
LP (Liqueed Petroleum Gas)
• LP gas is nontoxic, odorless and colorless when
produced.
• For Your Safety, LP gas has been given an odor
(similar to rotten cabbage) so that it can be smelled.
• LP gas is highly ammable and may ignite
unexpectedly when mixed with air.
LP Tank Filling
•
Use only licensed and experienced dealers.
• LP dealer must purge new tank before lling.
• Dealer should NEVER ll LP Tank more than 80% of
LP Tank volume. Volume of propane in tank will vary
by temperature.
• A frosty regulator indicates gas overll. Immediately
close LP Tank valve and call local LP gas dealer for
assistance.
• Do not release liquid propane (LP) gas into the
atmosphere. This is a hazardous practice.
• To remove gas from LP Tank, contact an LP dealer
or call a local re department for assistance. Check
the telephone directory under “Gas Companies” for
nearest certied LP dealers.
LP Tank Valve
Safety Cap
Retainer Strap
Safety Cap