Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 347
ipv6 ospf area <area index (0-2)> instance <0-255>
Configures the instance ID for the interface.
Command mode: Interface IP
[no] ipv6 ospf priority <priority value (0-255)>
Configures the priority value for the switch’s OSPFv3 interface.
A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that
the interface cannot be used as Designated Router (DR).
Command mode: Interface IP
[no] ipv6 ospf cost <1-65535>
Configures the metric value for sending a packet on the interface.
Command mode: Interface IP
[no] ipv6 ospf hello-interval <1-65535>
Configures the indicated interval, in seconds, between the hello packets, that the router
sends on the interface.
Command mode: Interface IP
[no] ipv6 ospf dead-interval <1-65535>
Configures the time period, in seconds, for which the router waits for hello packet from the
neighbor before declaring this neighbor down.
Command mode: Interface IP
[no] ipv6 ospf transmit-delay <1-1800>
Configures the estimated time, in seconds, taken to transmit LS update packet over this
interface.
Command mode: Interface IP
[no] ipv6 ospf retransmit-interval <1-1800>
Configures the interval in seconds, between LSA retransmissions for adjacencies belonging
to interface.
Command mode: Interface IP
Table 214 OSPFv3 Interface Configuration Options
Command Syntax and Usage