Technical data

BLADE OS 5.0 Command Reference
156
 Chapter 6: The Configuration Menu BMD00142, November 2009
To save the new configuration, enter the following command at any CLI prompt:
When you save configuration changes, the changes are saved to the active configuration block. The
configuration being replaced by the save is first copied to the backup configuration block. If you do
not want the previous configuration block copied to the backup configuration block, enter the
following instead:
You can decide which configuration you want to run the next time you reset the switch. Your
options include:
 The active configuration block
 The backup configuration block
 Factory default configuration
You can view all pending configuration changes that have been applied but not saved to flash
memory using the diff flash command. It is a global command that can be executed from any
menu.
For instructions on selecting the configuration to run at the next system reset, see “Selecting a
Configuration Block” on page 317.
# save
# save n