Blade 200 S Manual

9
EN
Left Side View Left Side View
Rear View Rear View
Control Direction Tests
Ensure the throttle hold is ON when doing the direction
control tests. Test the controls prior to the fi rst fl ight to
ensure the servos, linkages and parts operate correctly.
If the controls do not react as shown in the illustrations
below, confi rm the transmitter is programmed correctly
before continuing on to the Motor test.
Motor
Do not attempt to fl y the helicopter at this time. Place
the helicopter outdoors on a clean, fl at and level surface
(concrete or asphalt) free of obstructions. Always stay clear
of moving rotor blades.
CAUTION: Keep pets and other animals away
from the helicopter. Animals may injure themselves
if they attack or run toward the helicopter.
1. The model will emit 6 tones when the helicopter’s
ESC arms properly. Before you continue, confi rm that
throttle is at full low position.
2. Turn Throttle Hold OFF.
WARNING: Stay at least 30 feet (10 meters) away
from the helicopter when the motor is running.
3. Quickly increase the throttle and immediately return
it to the low position to check the motor rotation
direction. The main blades should spin clockwise
when viewing the helicopter from the top. The tail rotor
blades should spin counterclockwise when viewing the
helicopter from the right side.
NOTICE: If the main rotor blades are spinning
counterclockwise, reduce the throttle to low immediately.
Disconnect the battery from the helicopter and reverse
any two motor wire connections to the ESC and repeat
the motor control test.
Forward Cyclic
Left Cyclic
Backward Cyclic
Right Cyclic
Elevator (Forward and Backward Cyclic)
Aileron (Le and Right Cyclic)