User Manual

ManualsBrandsBlade ManualsHobby350 QX BNF Firmware 2.0 with SAFE Technology

Accessing Agility Mode

To access Agility Mode, a Spektrum DX6i or higher transmitter is required. On your transmitter‘s  ight mode channel (channel 5), adjust one of the endpoints (high or low) from

100% to 120%. If you adjust the high endpoint, Smart Mode will be replaced by Agility Mode. If you adjust the low endpoint, Stability Mode will be replaced by Agility Mode. To return

to normal operation, return the endpoint to 100%.

Agility Mode

• Solid Red LED Indicator

• Aerobatic: Capable of  ips and rolls

• Throttle provides proportional thrust: The throttle responds directly to the throttle input, giving the pilot direct control over hovering as well as ascent and descent rates.

For complete Agility Mode information, refer to the Blade 350 QX Firmware 1.0 full manual online at www.horizonhobby.com.

Blade

350 QX 2.0 Firmware 2.0 Agility Mode Instructions

Blade is a registered trademark of Horizon Hobby, LLC.

45XXX Created: 03/2014

Summary of content (1 pages)

PAGE 1
® Blade® 350 QX 2.0 Firmware 2.0 Agility Mode Instructions Accessing Agility Mode To access Agility Mode, a Spektrum DX6i or higher transmitter is required. On your transmitter‘s flight mode channel (channel 5), adjust one of the endpoints (high or low) from 100% to 120%. If you adjust the high endpoint, Smart Mode will be replaced by Agility Mode. If you adjust the low endpoint, Stability Mode will be replaced by Agility Mode. To return to normal operation, return the endpoint to 100%.