User Manual

4
EN
Transmitter Setup (BNF)
Transmitter Model
Type
Reverse Setup
Throttle Cut Setup
Mode Setup Switch Positions Throttle Cut Return Home Dual Rate
Switch
High Rate
Low Rate
DX4e (New)* w/3-position switch
N/A N/A N/A N/A
Position 0 = SMART Mode
Lower throttle trim until motors stop turning
Press and Hold TRAINER/BIND Release to EXIT
Rate
100% fi xed
70% fi xed
Position 1 = Stability Mode Position 2 = Agility Mode
DX5e (New)* w/3-position switch
N/A N/A N/A N/A
Position 0 = SMART Mode
Lower throttle trim until motors stop turning
Press and Hold TRAINER/BIND Release to EXIT
Rate
100% fi xed
70% fi xed
Position 1 = Stability Mode Position 2 = Agility Mode
DX6i Acro
THRO-N ELEV-N GEAR-R AILE-N RUDD-N FLAP-N
ACT
Travel Adj: Gear (0)↑100%; F MODE (1) ↓40% FLAPS: Norm ←↑100; LAND ↓100 MIX 1: ACT; Gear → Gear ACT RATE D 0%; U + 100% SW MIX TRIM INH
GEAR 0; Mix 0 = SMART Mode
Press throttle cut
FLAP Position 0 = OFF FLAP Position 1 = Return Home
ELEV-AIL D/R 100% 70%
GEAR 1; Mix 0 = Stability Mode GEAR 1; Mix 1 = Agility Mode
DX7/7SE Acro
FLAP-R (6) Others-N
N/A
Travel Adj: GEAR (0)↑100%; GEAR (1) ↓40% MIX 1: FLAP → Gear OFF/ON RATE → -50%
0% SW: MIX OFFSET: 0
GEAR (0); Mix (0) = SMART Mode
Lower throttle trim until motors stop turning
FLAP Pos 0 = OFF FLAP Pos 1 = Return Home
ELEV-AIL D/R 100% 70%
GEAR (1); Mix (0) = Stability Mode GEAR (1); Mix (1) = Agility Mode