User Manual

10
EN
1.Lowerthrottleandthrottletrimtolowestsettings.
2.Powerontransmitter.
3.Installightbatteryinthebatteryholder.Connectthebatterycabletothe3-in-1controlunit.
NOTICE:DonotallowthehelicoptertomoveuntiltheblueLEDonthe3-in-1controlunitissolid.
NOTICE: AlwaysdisconnecttheLi-Pofromthereceiveroftheaircraftwhennotying.Failuretodosowill
render the battery unusable.
Consult local laws and ordinances before choosing a location to fly your aircraft. Selectalarge,openarea
awayfrompeopleandobjects.TheBlademCPXcanyindoorsinagymnasium.
CAUTION: PleasetakeafewminutestofamiliarizeyourselfwiththeBlademCPXprimarycontrolsbefore
attemptingyourrstight.TheBlademCPXismoreresponsivethanotherBlademicrohelicopters,suchas
theBlademSR.Seekhelpfromanexperiencedpilotifyouarenewtocollectivepitchhelicopters.
Takeo
Increase throttle and allow the helicopter time to increase the rotor head speed.
CAUTION: Donotgiveanyaileron,elevatororruddercommandsbeforetakeofforthehelicoptermaycrash
duringtakeoff.
Flying
The helicopter lifts off the ground when the rotor head reaches a suitable speed. Establish a low-level hover to
verifyproperoperationofyourhelicopter.Youwillnotneedtosetanytrim;theybarlessdesignofthemCPX
renders trim unnecessary.
For pilots new to collective pitch helicopters, familiarize yourself with your mCP X in normal mode. Discover the
ratesthattyouryingstyle.
CAUTION:Alwaysythehelicopterwithyourbacktothesuntopreventlossofightcontrol.
Landing
Establishalowlevelhover.Slowlylowerthethrottleuntilthehelicopterlands.
Flying the mCP X
Always keep
vehicle in sight
and under control.
Always
enable throttle hold
at rotor strike.
Always use
fully charged
batteries.
0
50
100
Always keep transmitter
powered on while
vehicle is powered.
Never operate
vehicle with
damaged wiring.
Never touch
moving parts.
Always keep
parts dry.
Always
keep moving
parts clean.
Always let parts
cool after use
before touching.
Always remove
batteries
after use.
Always remove
batteries before
disassembly.
Installing the Flight Battery