User Manual

5
EN
Battery Charging
Celectra™1-Cell3.7VVariableRateDCLi-PoCharger
Instructions
1.Connectpowersupplytoanappropriatepower
source.
2.Insertoutputplugfrompowersupplyintothepower
inputslotoftheVariableRateCharger.
3.Selecttheappropriatechargecurrentforyour
battery by pushing the + or -, which are the smaller
buttons to the right and left of the middle button.
(Whenchargingyour200mAhbattery,setthe
chargerto0.7amps.)
4.ConnectthechargeadaptertotheChargerlead.
Matchthereddotsonboththechargeadapterand
the Charger lead.
5.ProperlyconnectbatterytotheChargerlead.Matchthereddotsonboththebatteryandchargerconnectors.
6.PressandreleasethestartbuttonontheVariableratecharger(thelargestbuttoninthemiddle).
NOTICE: Only use the included charger.
CAUTION: NEVER attempt to power
the charger from an AC outlet without
the use of a proper AC to DC adapter/power
supply.
CAUTION: DO NOT connect charged
or discharged Li-Po batteries if the
power supply is connected to the charger
while power supply is not connected to a
power source. Doing so will discharge and
possibly damage the batteries.
LED functions under normal operation:
SINGLE SOLID LED ShowsChargeCurrent
SINGLE LED FLASHING Charging
MULTIPLE LEDs FLASHING Charge Almost Complete
LEDs SWEEPING SIDE TO SIDE Charge Complete
First Flight Preparation
Remove and inspect contents•
Beginchargingtheightbattery•
Install the four AA batteries in the transmitter•
(RTF ONLY)
Installthebladesappropriatetoyouryingstyle.•
The Fast Flight Main Rotor Blade Set is best
outdoors or for a smoother flying style. The
High-performance Main Rotor Blade Set is
best used indoors or for aggressive aerobatic
maneuvers
Installtheightbatteryinthehelicopter(onceit•
hasbeenfullycharged)
Programyourcomputertransmitter(BNFOnly)•
Test the controls•
Familiarize yourself with the controls•
Findasuitableareaforying•
Flying Checklist
Always turn the transmitter on first ❏
Plugtheightbatteryintotheleadfromthe ❏
3-in-1controlunit
Allowthe3-in-1controlunittoinitializeand ❏
arm properly
Fly the model ❏
Landthemodel ❏
Unplugtheightbatteryfromthe3-in-1 ❏
control unit
Always turn the transmitter off last ❏