User Manual

7
EN
®
Transmitter and Receiver Binding
If you purchased an RTF model, the transmitter is bound to the model at the factory.
To bind or re-bind your mCP X to your chosen transmitter, please follow the directions below:
BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUnique
Identier)codeofasinglespecictransmitter.Youneedto‘bind’yourchosenSpektrum
™
or JR
®
DSM
®
technology equipped aircraft transmitter to the receiver for proper operation.
NOTICE:UsetheNon-ComputerRadiobindinginstructionsifyouareusingaDX4eorDX5etransmitter
with the mCP X BNF.

Binding Procedure for Non-Computer Radio (DX4e, DX5e)
1.Disconnecttheightbatteryfromthehelicopter.
2.Poweroffthetransmitterandmoveallswitchestothe0position.
3.Connecttheightbatteryinthehelicopter.The3-in-1ControlunitLEDashesafter5seconds.
4.Pushinonthetrainerswitchorbuttonwhilepoweringonthetransmitter.
5.MovetheruddercontrolsticktofullleftafterthetransmitterLEDlightsashtwice.
6.Releasethetrainerswitchbutton.Continuetoholdtheruddercontrolsticktofullleftuntiltheblue
LEDonthe3-in-1controlunitissolid.
7.Releasetheruddercontrolstick.
8.Pushinonthetrainerswitchbutton.TheblueLEDonthe3-in-1controlunitashestoconrmthe
helicopter is in non-computer mode.
9.Disconnecttheightbatteryandpowerthetransmitteroff.

Binding Procedure for Computer Radios:
1.Disconnecttheightbatteryfromthehelicopter.
2.Poweroffthetransmitterandmoveallswitchestothe0position.
3.Connecttheightbatteryinthehelicopter.The3-in-1controlunitLEDashesafter5seconds.
4.Putthetransmitterinbindmodewhilepoweringonthetransmitter.
5.Releasethebindbuttonafter2-3seconds.ThehelicopterisboundwhentheblueLEDonthe
3-in-1controlunitissolid.
6.Disconnecttheightbatteryandpowerthetransmitteroff.
Note: The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt
modeswitchisnotinthe0position.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.
ForalistofcompatibleDSMtransmitters,pleasevisitwww.bindny.com.
Note: If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode; repeat binding procedure.