230 S Smart Manual

14
EN
The 230 S Smart BNF ight controller may be programmed from any compatible Spektrum transmitter
(visit SpektrumRC.com for more information).
The ight controller shipped with BNF models has a range of adjustable parameters suitable for the 230 S Smart Helicopter
and is not intended for use in other aircraft.
It is important to use the included servos with the BNF ight controller because the adjustable parameters available for
the SPMAR6250MHX are designed around the recommended servos. It is possible there may not be enough range for the
helicopter to be tuned when using alternative servos.
Entering the Advanced Parameters Men
u
With the helicopter bound to the transmitter and powered on, enter the Function List and select Forward Programming.
The list of adjustable parameters and the range of values available for tuning have been tailored for this helicopter. Make
small changes to one parameter at a time and test y the changes before changing the parameter further or changing a
different parameter.
Calibration Procedure
:
If the helicopter is experiencing drift issues, perform the following calibration. The calibration procedure may also be
needed following crash repairs.
1. Ensure the surface used for calibration is level.
2. Power on the transmitter and activate throttle hold.
3. Connect the ight batter to the ESC and allowing the
model to initialize.
4. Turn Throttle Hold ON.
5. Using a bubble level as shown below, level the
helicopter by placing a shim under the landing skid.
6. Enter the Function List on your transmitter.
7. Select Forward Programming.
8. Select System Setup.
9. Select Calibration.
10. Select Apply and the calibration will begin. The
LED will ash yellow indicating the calibration is
proceeding normally. If the LED changes to red this
indicates the model is not near level or the model was
moved, in this case the calibration starts over.
11. After the calibration is successfully completed, the
receiver LED will will change to a slow green ash
which indicates the calibration has completed.
12. Proceed to the pre-ight check list procedure before
ying your model.
Applies to forward programming capable Spektrum Transmitters including
DX6e, DX8e, DX6G2, DX7G2, DX8G2, DX9, iX12, DX18, iX20, DX20, NX6, NX8, NX10
Factory Reset
If the process of tuning the 230 S Smart helicopter results in undesirable ight performance, you can reset the settings
back to factory defaults by selecting the Factory Reset option in Forward Programming.
1. Enter the Function List
2. Select Forward Programming
3. Select System Setup
4. Select Factory Reset
5. Select Apply
6. Perform the Setup->Swashplate->Sub Trim function
and ensure the servos are properly trimmed.
7. Proceed with the pre-ight check list procedure
before ying the model.
The 230 S Smart default settings are appropriate for most users. We recommend ying with the default parameters
before making any adjustments.
Advanced Tuning (Forward Programming)
Bubble level
Foam blade holder