User Manual

8
EN
NOTICE: If the swashplate moves up and down when the trainer switch is moved, the
helicopter is in computer transmitter mode. Repeat the binding procedure.
Elevator
Elevator down Elevator up
Left Side View Left Side View
Transmitter and Receiver Binding
Binding is the process of programming the receiver of the control unit to recognize the GUID
(Globally Unique Identier) code of a single specic transmitter. You need to ‘bind’ your chosen
Spektrum
™
DSM2
®
/ DSMX
®
technology equipped aircraft transmitter to the receiver for proper
operation.
If you purchased an RTF model, the transmitter is bound to the model at the factory.
If for any reason you need to re-bind your Nano S2 to the MLP6DSM, follow the directions below:
Binding Procedure for Computer Radios (BNF)
1. Disconnect the ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the ight battery to the helicopter. The 3-in-1 Control unit LED ashes after 5 seconds.
4. Push the bind switch/button while powering on the transmitter.
5. After 2–3 seconds, release the bind switch/button.
6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right
until the blue LED on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Disconnect the ight battery and power the transmitter off.
NOTICE: The throttle will not arm if the transmitter’s throttle control is not put at the lowest
position and the stunt mode switch is not in the 0 position.
If you encounter problems, refer to the troubleshooting guide for other instructions. If needed,
contact the appropriate Horizon Hobby Product Support ofce.
Control Tests
Ensure the throttle hold is ON when
doing the direction control tests. Test the
controls prior to the rst ight to ensure the
servos, linkages and parts operate correctly.
If the controls do not react as shown in the
illustrations below, conrm the transmitter is
programmed correctly.
To bind your Nano S2 to your chosen transmitter, follow the directions below:
Binding Procedure for the MLP6DSM (RTF)
1. Disconnect the ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the ight battery to the helicopter. The 3-in-1 Control unit LED ashes after 5 seconds.
4. Push and hold the bind/panic button/trigger and hold the rudder control stick to full left while
powering on the transmitter.
5. Release the bind/panic button/trigger. Continue to hold the rudder control stick to full left until the
LED on the 3-in-1 control unit is solid.
6. Release the rudder control stick.
7. Disconnect the ight battery and power the transmitter off.