User Manual

7
EN
H A B C D E F G H
Mode 1 Power
LED
Aileron (Left/Right)
Throttle (Up/Down)
Throttle
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Elevator
Trim
Rudder (Left/Right)
Elevator (Up/Down)
Mode 2 Power
LED
Aileron (Left/Right)
Elevator (Up/Down)
Elevator
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Throttle
Trim
Rudder (Left/Right)
Throttle (Up/Down)
Transmitter Control
DF
C
G
H
E
A
B
1. Lower the throttle to the lowest setting.
2. Power on the transmitter.
3. Install the battery in the helicopter by sliding it into the battery mounting supports/slots just below the main
gears. Slide the battery into the slots with the label facing downward and the connector oriented toward the
back of the helicopter.
4. Connect the battery cable to the 4-in-1 control unit.
NOTICE: Do not allow the helicopter to move until the blue LED on the 4-in-1 control unit is solid.
CAUTION: Always disconnect the Li-Po battery from the aircraft ESC when not flying to avoid over-
discharging the battery. Batteries discharged to a voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and potential fire when Batteries are charged.
Installing the Flight Battery
2
1
3
2
1
3
NOTICE: When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing.
The middle or neutral trim position is heard as a middle tone in the pitch range of the sounds. The end of the
control range is sounded by a series of beeps.