User Manual

Bind
Throttle Hold
Du al Rate Switch
Installing the DXe Transmitter Batteries (RTF)
DXe Transmitter Control (RTF)
The LED indicator fl ashes and the transmitter beeps progressively faster as the
battery voltage drops.
Replace the transmitter batteries when the transmitter begins to beep.
CAUTION: NEVER remove the transmitter batteries while the model is
powered on. Loss of model control, damage or injury may occur.
CAUTION: If using rechargeable batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries may cause the batteries
to burst, resulting in injury to persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced with an incorrect type.
Dispose of used batteries according to national regulations.
A
B
C
D
E
F
G
LED Indicator
ABCDEFG
Mode 1
Aileron (Left/Right)
Throttle (Up/Down)
Throttle Trim Aileron Trim ON/OFF Switch Rudder Trim Elevator Trim
Rudder (Left/Right)
Elevator (Up/Down)
Mode 2
Aileron (Left/Right)
Elevator (Up/Down)
Elevator Trim Aileron Trim ON/OFF Switch Rudder Trim Throttle Trim
Rudder (Left/Right)
Throttle (Up/Down)
5
EN
Program your transmitter before attempting to bind or fl y the helicopter. Transmit-
ter programming values are shown below for the Spektrum DX6i, DX7s, DX6, DX7,
DX8, DX9, DX18 and DX20.
The fi les for transmitters using SpektrumAirWare
™
are also available for download
online at www.spektrumrc.com.
To use a Spektrum
™
DXe transmitter other than the one included in the RTF version,
download the Blade
®
330 S DXe model setup available at www.spektrumrc.com or
use the appropriate programming cable and the PC or mobile app to program the
transmitter.
Transmitter Setup (BNF)
DXe
D/R & Expo
Chan Switch Pos (Ail D/R) D/R Expo
AILE
0 100/100 0
1 85/85 0
2 85/85 0
ELEV
0 100/100 0
1 85/85 0
2 85/85 0
RUDD
0 100/100 0
1 85/85 0
2 85/85 0
Model Type HELI
Swash Type 1 servo Normal
F-Mode Setup
Flight Mode F Mode
Hold Hold
DX7s, DX8
Chan Travel Reverse
THR 100/100 Normal
AIL 100/100 Normal
ELE 100/100 Normal
RUD 100/100 Normal
Chan Travel Reverse
GER 50/50 Reverse
PIT 100/100 Normal
AX2 100/100 Normal
Servo Setup
FUNCTION LIST
SYSTEM SETUP
Throttle Curve
Switch Pos (F Mode) Pt 1 Pt 2 Pt 3 Pt 4 Pt 5
N 0 65 65 65 65
17070707070
28080808080
Pitch Curve
Switch Pos (F Mode) Pt 1 Pt 2 Pt 3 Pt 4 Pt 5
N 25 37 50 75 100
1 0 25 50 75 100
2 0 25 50 75 100
HOLD 25 37 50 75 100
SW Select
Trainer Aux 2
F Mode Gear
Gyro INH
Mix INH
Hold INH
Knob INH
Frame Rate
11ms
DSMX
Throttle Hold
Throttle 0%
Fli ght Mode Switch
0 = Normal Mode
1 = Stunt Mode 1
2 = Stunt Mode 2