User Manual

8
EN
Installing the Flight Battery
1. Lower the throttle stick to the lowest position
and center all trims.
2. Set the Flight Mode Switch to Stability Mode (FM0).
3. Power ON the transmitter.
4. Slide the battery into the back of the quadcopter, all
of the way forward through the battery loop as shown.
5. Connect the power lead to the battery, noting the correct
polarity.
CAUTION: Connecting the battery to the control
board with reversed polarity will cause damage
to the control board, the battery or both. Damage caused
by incorrectly connecting the battery is not covered
under warranty.
6. Place the quadcopter upright on a fl at surface and leave
it still until the LEDs glow solid white in the front and red
in the rear, indicating the quadcopter is ready for fl ight.
If the LEDs continuously pulse slowly, no valid transmit-
ter signal has been acquired. Proceed to the Transmitter
and Receiver Binding section to bind the quadcopter and
transmitter.
If the LEDs alternately fl ash front and rear, the battery
is below 3.5V. The quadcopter will not allow takeoff.
Charge the battery and re-install.
If you experience issues during initialization, refer to the
Troubleshooting Guide at the back of the manual.
CAUTION: Always disconnect the Li-Po battery
from the aircraft when not fl ying to avoid over-
discharging the battery. Batteries discharged to a voltage
lower than the lowest approved voltage may become
damaged, resulting in loss of performance and potential
fi re when batteries are charged.
To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support offi ce. For a list of compatible DSM
®
transmitters,
please visit www.bindnfl y.com.
Transmitter and Receiver Binding
General Binding Procedure (BNF)
1. Refer to the Transmitter Setup section to correctly setup your transmitter.
2. Lower the throttle stick to the lowest position and center all trims on your transmitter.
3. Power off the transmitter and move all switches to the 0 position.
4. Install the fl ight battery in the quadcopter. Hold the quadcopter inverted until the LEDs fl ash rapidly.
5. Set the quadcopter upright.
6. Put the transmitter into bind mode while powering on the transmitter.
7. The quadcopter is bound when the onboard LEDs stop fl ashing and then glow solid.
8. Disconnect the fl ight battery and power the transmitter off.
MLP6 Binding Procedure (RTF)
1. Disconnect the fl ight battery from the quadcopter.
2. Center all trims on your transmitter. The trims are centered when the transmitter emits a longer tone when pressing
the trim buttons.
3. Power off the transmitter and move the throttle stick to the down/off position.
4. Install the fl ight battery in the quadcopter. Hold the quadcopter inverted until the LEDs fl ash rapidly.
5. Set the quadcopter upright.
6. Push in and hold down the left stick (you will hear a ‘click’) while powering on the transmitter.
7. Release the left stick. The transmitter will beep and the power LED will blink.
8. The quadcopter is bound when the onboard LEDs stop fl ashing and then glow solid.
9. Disconnect the fl ight battery and power the transmitter off.
Your RTF transmitter comes prebound to the model. If you need to re-bind, follow the directions below.