User Manual

ManualsBrandsBlade ManualsHelicopters350 QX3 AP Combo RTF with SAFE Technology

Return Home

NOTICE: Return home will only function if the

350 QX3 has GPS lock.

• When this feature is activated, the LED will rapidly

ﬂ ash red.

• The 350 QX3 will ﬂ y back to its assigned home loca-

tion and land. After landing, the motors may take up

to 5 seconds to stop.

• The return home function may be cancelled by

switching back to Smart or AP Mode using the ﬂ ight

mode switch.

• To restart the props after landing in Return Home,

move both transmitter sticks to the bottom inside

corners and then back to center.

CAUTION: The 350 QX3 will not recognize the

SAFE Circle feature when Return Home is used.

Activating Return Home may cause the 350 QX3 to

ﬂ y directly over the pilot if the aircraft was ﬂ own to a

position behind where the pilot was standing when the

home position was established.

Activating Return Home

Landing

To land the 350 QX2 AP there are two options:

• Guide the aircraft to where you wish to land. Slowly

reduce the throttle below half to descend and land.

When the quadcopter has landed, lower the throttle

completely and press the bind button to stop the

motors.

• Activate the Return Home function to return the

350 QX3 to the assigned home location and land

automatically.

CAUTION: Do not activate the Return Home

function if the 350 QX3 is showing the low

battery indication. Manually land the aircraft

immediately.

After Your Flight

1. Turn off the power switch on the 350 QX3.

2. Turn off the power to your transmitter.

3. Unplug and remove the battery from the 350 QX3.

Recharge your battery following the charging

warnings and instructions.

CAUTION: Always disconnect the Li-Po bat-

tery from the aircraft when not ﬂ ying to avoid

over-discharging the battery. Batteries discharged to a

voltage below the lowest approved voltage may become

damaged, resulting in loss of performance and potential

ﬁ re when batteries are charged.

Location alert

The motors will beep under the following conditions:

• At any time the props stop spinning after they have

been initialized.

• After 30 seconds of no throttle input (waiting armed

on the ground).

This will alert the pilot to the location of the aircraft if it

lands in a location with low visibility.

Beeping will continue until the battery can no longer

supply enough power to the motors.

If the quadcopter crash lands and one or more motors

are stopped by an impact, the quadcopter enters

emergency mode. The LED will ﬂ ash white and the

motors will beep loudly.

Motor Stop