User Manual

Takeo

Increase the throttle until the model is approximately 2 ft. (600mm) off the ground and check the trim so the model

ﬂ ies as desired. Once the trim is adjusted, begin ﬂ ying the model.

Typical ﬂ ight times for the included battery range from 3 to 4 minutes.

Low Voltage Cuto (LVC)

LVC decreases the power to the motors when the battery voltage gets low. When the motor power decreases and the

front and rear FC LEDs ﬂ ash red, land the aircraft immediately and recharge the ﬂ ight battery.

LVC does not prevent the battery from over-discharge during storage.

NOTICE: Repeated ﬂ ying to LVC will damage the battery.

Landing

To land, slowly decrease the throttle while in a low-level hover. After landing, hold the arm/disarm switch until the

motors have stopped, then remove the battery. Fully charge your battery before storing it. During storage, make sure the

battery charge does not fall below 3V per cell.

Flying the Switch

™

Quadcopter

Throttle

Throttle down

Throttle up

Left Side View

Descend

Climb

Switching from Quadcopter Operation to Air Wing Operation

To switch from quadcopter operation to air wing operation, slide the two rear fans down out of the clips on the main

frame and slide them into the clips at the rear of the wing base plate. Seat the main frame into the slot in the wing with

the two front fans attached ensuring the fans click into their respective openings in the wing.

To select Air Mode, press both sticks to the outside upper corners for 3 seconds. The ﬂ ight

mode LED will glow solid white to indicate Air mode.

Select ﬂ ight modes by pushing down on the right stick. Ensure the ﬂ ight mode switch is in the

desired position before ﬂ ying.

• Beginner mode (switch position 0); The Aileron and Rudder controls are combined on the right

stick to simplify ﬂ ight controls for new users.

• Expert Mode (Switch position 2); Standard ﬁ xed-wing ﬂ ight controls for more experienced

pilots.

Air Mode

Air Mode Operation (Beginner mode)