Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com and click on the support tab for this product.
Table of Contents First Flight Preparation......................................................4 Flying Checklist................................................................4 Charging Warnings...........................................................4 Battery Charging...............................................................4 Transmitter Setup Table....................................................5 SAFE Technology..............................................................
First Flight Preparation Flying Checklist • Remove and inspect contents • Begin charging the flight battery • Program your computer transmitter • Familiarize yourself with the controls • Install the flight battery in the quadcopter (once it has been fully charged) • Bind your transmitter • Find a suitable area for flying ❏❏Always turn the transmitter on first ❏❏ Plug the flight battery into the lead from the 4-in-1 ESC ❏❏ Allow the receiver and ESC to initialize and arm ❏❏Fly the model ❏❏Land the
Transmitter Setup Table Transmitter "Model Type" DX6i Acro DX7S Acro DX8 DX6, DX7, DX9, DX18 Acro Airplane Transmitter Programming Setup List GEAR POS (0) GEAR : ↑100%; GEAR/F MODE POS (1) GEAR : ↓48% Reverse: Gear – R Throttle Cut: ACT Flaps: Norm (DN) 100% Land (DN) 100% Mixing Mix 1: ACT; Gear > Gear ACT Rate D 0%, U -100% SW: GEAR, Trim: INH Mix 2: ACT; Gear > Gear ACT Rate D 0%, U +100% SW: ELE D/R, Trim INH System Setup Switch Select Trainer: Aux1 Flaps: Gear F M
Understanding the Primary Flight Controls If you are not familiar with the controls of your quadcopter, take a few minutes to familiarize yourself with them before attempting your first flight.
Installing the Flight Battery 1. Lower the throttle. 2. Power on the transmitter. 3. Center the throttle trim. 4. Attach hook material to the quadcopter frame and loop material to the battery. 5. Install the flight battery on the quadcopter’s bottom frame. Secure the flight battery using the battery o-ring. Connect the battery cable to the ESC, noting correct polarity. 6. Do not move the quadcopter until the receiver initializes. 7.
Preparing the Mach 25TM Quadcopter for Flight 1. Before each flight, ALWAYS power on the transmitter before connecting the flight battery to the control unit. After each flight, disconnect the flight battery from the control unit before powering off the transmitter. NOTICE: Connecting the flight battery before powering on the transmitter can start the binding process. Please see the Transmitter and Receiver Binding section of this manual for more information. 2.
Flying the Mach 25TM Quadcopter Takeoff When you are prepared to fly, start the motors by moving both sticks to the bottom inside corners, then back to center. Increase the throttle until the model is approximately 2 ft. (600mm) off the ground and check the trim so the model flies as desired. Once the trim is adjusted, begin flying the model. Typical flight times for the included battery range from 5–7 minutes.
Troubleshooting Guide Problem Quadcopter control response is inconsistent or requires extra trim to neutralize movement Quadcopter control is mixed, roll with pitch input or pitch with roll input Quadcopter will not respond to throttle Quadcopter does not function and smells burnt after connecting the flight battery Quadcopter has reduced flight time or is underpowered Difficulty binding Difficulty connecting (after binding) Crashes immediately upon lift-off EN Possible Cause Solution Quadcopter n
Exploded View 11 10 16 1 9 16 M1 16 14 8 4 5 M2 6 7 M4 15 3 M3 2 17 Battery Electronics Wiring Diagram 1 13 12 18 Parts Listings 1 2 3 4 5 6 7 Part # Description BLH8901 BLH8902 BLH8903 BLH8904 BLH8905 BLH8906 BLH8907 Frame Set: Mach 25 FPV Camera Mount: Mach 25 FPV Arm Clamp (4): Mach 25 FPV Arms (4): Mach 25 FPV Motor Mounts: Mach 25 FPV LED Set: Mach 25 FPV LED Cover Set (4): Mach 25 FPV Brushless Motor; 2300 KV: Mach 25 FPV Self-Tightening Prop Adapter Set: Mach 25 FPV 8 BLH8908 9
Limited Warranty What this Warranty Covers Horizon Hobby, LLC (Horizon) warrants to the original purchaser that the product purchased (the "Product") will be free from defects in materials and workmanship at the date of purchase.
Warranty and Service Contact Information Country of Purchase Horizon Hobby Horizon Service Center (Repairs and Repair Requests) United States of America Horizon Product Support (Product Technical Assistance) Sales United Kingdom Germany France China Service/Parts/Sales: Horizon Hobby Limited Horizon Technischer Service Sales: Horizon Hobby GmbH Service/Parts/Sales: Horizon Hobby SAS Service/Parts/Sales: Horizon Hobby – China Contact Information Address servicecenter.horizonhobby.
