Nano CP S Manual

13
EN
Problem Possible Cause Solution
LED on receiver
fl ashes
rapidly and aircraft
will not bind to trans-
mitter
(during binding)
Transmitter is too near aircraft
during binding process
Power off transmitter, move trans-
mitter a
larger distance from aircraft, dis-
connect and reconnect fl ight bat-
tery to aircraft and follow binding
instructions
Bind switch or button was not
held while transmitter was
powered on
Power off transmitter and repeat
bind process
Aircraft or transmitter is too
close to large metal object,
wireless source or another
transmitter
Move aircraft and transmitter to
another
location and attempt binding again
LED on receiver
fl ashes rapidly and
aircraft will not re-
spond to transmitter
(after binding)
Less than a 5-second wait
between fi rst powering on
transmitter and
connecting fl ight battery to
aircraft
Leaving transmitter on, disconnect
and
reconnect fl ight battery to aircraft
Aircraft is bound to a differ-
ent model memory (Model-
Match
TM
radios only)
Select correct model memory on
transmitter and disconnect and
reconnect fl ight battery to aircraft
Flight battery/transmitter bat-
tery charge is too low
Replace/recharge batteries
Transmitter may have been
bound to a different model
(or with a different DSM
®
Protocol)
Select the right transmitter or bind
to the new one
Aircraft or transmitter is too
close to large metal object,
wireless source or another
transmitter
Move aircraft and transmitter to
another
location and attempt connecting
again
Helicopter vibrates or
shakes in fl ight
Damaged rotor blades,
spindle or blade grips
Check main rotor blades and blade
grips for cracks or chips. Replace
damaged parts.
Replace bent spindle