Nano CP S Manual

ManualsBrandsBLADE ManualsHobbyNano CP S RTF

Binding Procedure for the MLP6DSM (RTF)

1. Disconnect the ﬂ ight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the ﬂ ight battery to the helicopter. The 3-in-1 Control unit LED ﬂ ashes after 5 seconds.

4. Push and hold the “panic” trigger/button and hold the rudder control stick to full left while

powering on the transmitter.

5. Release the trainer switch/button. Continue to hold the rudder control stick to full left until the

blue LED on the 3-in-1 control unit is solid.

6. Release the rudder control stick.

7. Push the trainer switch/button. The blue LED on the 3-in-1 control unit ﬂ ashes to conﬁ rm the

helicopter is in non-computer mode.

8. Disconnect the ﬂ ight battery and power the transmitter off.

NOTICE: If the swashplate moves up and down when the trainer switch is moved, the

helicopter is in computer transmitter mode. Repeat the binding procedure.

Elevator

Elevator down Elevator up

Left Side View Left Side View

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID

(Globally Unique Identiﬁ er) code of a single speciﬁ c transmitter. You need to ‘bind’ your chosen

Spektrum

™

DSM2

DSMX

technology equipped aircraft transmitter to the receiver for proper

operation.

If you purchased an RTF model, the transmitter is bound to the model at the factory.

If for any reason you need to re-bind your Nano CPS to the MLP6DSM, follow the directions below:

Binding Procedure for Computer Radios (BNF)

1. Disconnect the ﬂ ight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the ﬂ ight battery to the helicopter. The 3-in-1 Control unit LED ﬂ ashes after 5 seconds.

4. Push the bind switch/button while powering on the transmitter.

5. After 2–3 seconds, release the bind switch/button.

6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right

until the blue LED on the 3-in-1 control unit is solid.

7. Release the rudder control stick.

8. Disconnect the ﬂ ight battery and power the transmitter off.

NOTICE: The throttle will not arm if the transmitter’s throttle control is not put at the lowest

position and the stunt mode switch is not in the 0 position.

If you encounter problems, refer to the troubleshooting guide for other instructions. If needed,

contact the appropriate Horizon Hobby Product Support ofﬁ ce.

Control Tests

Ensure the throttle hold is ON when

doing the direction control tests. Test the

controls prior to the ﬁ rst ﬂ ight to ensure the

servos, linkages and parts operate correctly.

If the controls do not react as shown in the

illustrations below, conﬁ rm the transmitter is

programmed correctly.

To bind your Nano CPS to your chosen transmitter, follow the directions below: