BLH7600 Nano QX Quadcopter Manual

1. Lower the throttle and throttle trim to the lowest settings.

2. Power on the transmitter.

3. Flip the quadcopter upside-down and install the battery by sliding it into the battery mounting slot below the

4-in-1 control unit. Slide the battery into the slots with the label facing upward so that the battery key, molded into

the battery end-cap, comes in contact with the key on the battery slot.

4. Connect the battery cable to the 4-in-1 control unit, matching the red mark on the battery to the red mark on the

connector.

5. Place the nano QX on its skids on a ﬂ at surface and leave the aircraft still until the LED on the 4-in-1 control unit is

solid blue (not blinking)

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.

Installing the Flight Battery

12 3

3. Always disconnect the ﬂ ight battery from the charger immediately upon completion of charging.

CAUTION: Only use chargers speciﬁ cally designed to charge the included Li-Po battery. Failure to do so could

result in ﬁ re, causing injury or property damage.

CAUTION: Never exceed the recommended charge rate.

LED Indications

When you make the connection successfully, the LED on the charger turns solid red, indicating charging has begun. Charging

a fully discharged (not over-discharged) 150mAh battery takes approximately 30–40 minutes. The light goes out when the

charge is complete.

CHARGING (Solid Red)

MAX CHARGE (OFF)

CAUTION: Once charging is complete, immediately remove the battery. Never leave a battery connected to the

charger.