Scimitar 170 FPV Manual

7
EN
The transmitter included with the RTF version of this aircraft is pre-bound to the receiver at the factory. If it becomes necessary
to re-bind the transmitter to the receiver, follow the binding procedure below.
To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.
Transmitter and Receiver Binding
If you encounter problems, obey binding instructions and refer to the
troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support offi ce. For a
list of compatible DSM
®
transmitters, please visit www.bindnfl y.com.
Failsafe
The included receiver does not have failsafe capabilities. Failsafe is detected at the fl ight controller. In the event of a loss of signal
to the receiver the fl ight controller will cut power to the motors to prevent a fl y-away situation.
DXe Transmitter Control (RTF)
ABCDEF
Mode 1
Aileron (Left/Right)
Throttle (Up/Down)
Throttle
Trim
Aileron
Trim
Rudder
Trim
Elevator
Trim
Rudder (Left/Right)
Elevator (Up/Down)
Mode 2
(Default)
Aileron (Left/Right)
Elevator (Up/Down)
Elevator
Trim
Aileron
Trim
Rudder
Trim
Throttle
Trim
Rudder (Left/Right)
Throttle (Up/Down)
Dual Rate Switch
A
B
C
D
E
F
On/Off Switch
LED Indicator
Fli ght Mode Switch
0 = Angle Mode
1 = Air Mode
2 = Acro Mode
Bind Switch
Motor Arm/Disarm Switch
Binding Procedure
1. Select the correct model in your transmitter.
2. Power off your transmitter.
3. Lower the throttle fully.
4. Power the quadcopter on while pressing the bind button through the
left side of the canopy with the end of a hex driver, as shown in the
illustration.
5. Follow the procedures of your speci c transmitter to enter Bind Mode.
6. The receiver LED glows solid orange indicating binding was successful.