User Manual

Put the helicopter on a ﬂat, level surface.

The helicopter gyro stabilizes at this time. Do not

allow the helicopter to move until the red LED on

the helicopter is solid.

Before Flying

CAUTION: ThebatteryincludedwithyourScoutCXiskeyedtoonlybeinsertedwiththetopofthebattery

facing up. Do not force it in with the opposite side facing up.

Transmitter Control

Rudder Trim

Charge LED

Elevator Trim

Throttle (Up/Down)

ON/OFF Switch

Power LED

Charging Port

Rudder (Left/Right)

Elevator (Forward/Backward)

 HoldthebottomoftheScoutCXasshownto

keepfromdamagingthecircuitboard.

Insert and connect the Li-Po battery into the

helicopterbatteryholder.Makesuretoalignthe

red dots on both the battery and the landing gear.

Lower the throttle to off, then power on the

transmitter.