Troubleshooting guide

Page 8
QUICK RELEASE DECK
The XTR-Street II comes equipped with a quick
release deck which gives you better access to the
batteries and the pc board. To open your quick
release deck, simply pull up from the rear of the
deck. (Fig. 6) The deck will release itself and it will
fold up towards the handlebars.
INTERGRADED SEAT BASE
The XTR-Street II comes with a seat base built in to
the scooter. Having this base built in to the scooter
will make it easy to install and uninstall the optional
seat assembly quickly and easy.
To install the seat, remove the pin from the side of the
scooter. (Fig. 7) Then place the seat post into the
base on the deck. (Fig. 8) Replace the pin in the side
of the scooter to secure the post. Place the seat on
the seat post and adjust to your preference and
tighten the nut on the underside of the seat.
Charging
Your XTR-Street II should come charged out of the box. Bladez still recommends
charging the unit for 6-8 hours prior to first use! Bladez also recommends charging your
XTR-Street II after every use and prior to storage.
Warning: DO NOT allow your Powerboard to go into deep discharge! – This will
damage the batteries.
BATTERIES
The batteries on the XTR-Street II come stored in a bag and are removable. This also
gives you the option to buy a second set of batteries which you can swap when one set
of batteries starts to run low. For more information about hot swap batteries inquire us
on the web at www.ebladez.com
or call us toll free at (866) ebladez.