User manual

14
SOMETHING NOT WORKING?
Before contacting your local Service
Centre, please make the following
checks:
The machine does not start up
■
The ON/OFF button has not been depressed
■
The door is not closed properly
■
No water is entering the machine (see: the machi-
ne does not fill)
■
The selector dial is not correctly positioned
The machine does not fill
■
The water taps are not turned on
■
The water supply has been disconnected
■
The inlet hoses are kinked
■
The water pressure is too low
■
The water inlet filters are clogged
■
The door is not closed properly
The machine empties as it fills
■
The end of the drain hose is too low
■
The end of the drain hose is submerged in water
■
Drain pipe has no vent-hole
The machine does not drain or spin
■
You have selected a gentle wash cycle with the
Rinse Hold option
■
The drain filter is clogged
■
The drain hose is kinked
■
The drainage system pipes are blocked
■
The drain hose extension is incorrect
The machine leaks or overflows
■
Too much detergent
■
Unsuitable detergent
■
The inlet hose(s) is (are) loose
■
The detergent dispenser drawer or recess is clog-
ged
■
The end of the drain hose is not securely positio-
ned
■
The drainage system pipes are blocked
The machine vibrates or is noisy
■
The internal packing has not been removed
■
The machine is not level
■
The machine is in contact with the wall or furniture
■
The washing load is badly distributed
■
The machine is overloaded
The door does not open
■
The safety device has locked it
■
Water in the tub: the door cannot be opened if
water is present in the tub.
If, after the above checks, there is still a fault, call
your local Service Centre.
Please make sure you give the model and serial num-
ber of the appliance.
This information can be
found on the rating plate
(see picture).
Mod. ..........
Prod. No. ...........
Ser. No. .........
Rating plate
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042