Dishwasher Instruction Manual BDW8345X
CONTENTS Technical specifications …………………………………………………….. Conformity with the standards and Test data …………………………….. 4 4 Safety information and Recommendations………………………………….. • Recycling .......………………………......................................................... • Safety information …………………………………………………………… • Recommendations …...……………………………………………………… • Items not suitable for dishwashing ………………………………………… 5 5 5 8 9 Installing the machine ………………………………………………………….. • Positioning the machine …………………………………………………….
Loading your dishwasher .……………………………………………………. • Alternative basket loads …………………………………………………... 18 22 Programme descriptions .…………………………………………………….. • Programme items ………………………………………………………….. 24 24 Getting familiar with your machine …………………………………………… 25 Switching on the machine and selecting a programme……………........ • Switching on the machine…………………………………………………. • Programme follow-up ……………………………………………………… • Changing a programme …………………………………………………… • Changing a programme with resetting …………………………………..
3 1. 2. 3. 4. 5. 6. 9 10 11 Worktop Upper basket with racks Upper spray arm Lower basket Lower spray arm Filters 7. 8. 9. 10. 11. Rating plate Control Panel Detergent and rinse-aid dispenser Upper basket track latch Cutlery basket 8 7 5 6 4 3 2 1 Ceiling Spray Arm: It provides better washing for the dishes at upper basket. 13 Turbo Drying Unit: This system provides better drying performance for your dishes.
Technical specifications Capacity 15 place settings Height 850 mm Height (without worktop) 820 mm Width 598 mm Depth 598 mm Net Weight 56 kg Electricity input 220-240 V, 50 Hz Total Power 2200 W Heating Power 2000 W Pump Power 100 W Drain Pump Power 30 W Water supply pressure 0.03 MPa (0,3 bar)-1 MPa (10 bar) Current 10 A Producer company has its right to amend design and technical specifications reserved.
SAFETY INFORMATION AND RECOMMENDATIONS Recycling • Certain components and the packaging of your machine have been produced from recyclable materials. • Plastic parts are marked with international abbreviations: (>PE< , >PS< , >POM<, >PP<, ) • Cardboard parts have been produced from recycled paper and they should be disposed of into waste paper collection containers for recycling. • Such materials are not suitable for being disposed of into garbage bins. They should be delivered to recycling centres instead.
• Check whether the indoor electrical fuse system is connected according to the regulations. • All electrical connections must match the values indicated on the rating plate. • Pay special attention and be sure that the machine does not stand on the electricity supply cable. • Never use an extension cord or a multiple socket for making a connection. The plug should be comfortably accessible after the machine has been installed.
• Due to danger of explosion, do not put into the machine’s washing section any chemical dissolving agents such as solvents. • Check whether plastic items are heat-resistant before washing them in the machine. • Children shall not play with the appliance.Cleaning and user maintenance shall not be made by children without supervision. • Do not put into your machine those items which are not suitable for dishwashing. Also, do not fill any basket above its capacity.
• If EnergySave option is selected as "Yes", The door will be opened at the end of the program. Do not force to close the door to avoid damaging the auto door mechanism. The door must be open during 30 minutes to get effective drying.( in models with auto door opening system ) Warning: Do not stand in front of the door after the signal sounds belonging auto-open. For your children’s safety • After removing the machine’s packaging, make sure that the packaging material is out of reach of children.
• Use the pre-wash programme only whenever necessary. • Place such hollow items as bowls, glasses and pots into the machine in such a way that they will face down. • You are recommended not to load into your machine any dishes different or more than indicated.
Do not put your machine in any location where there is the probability for the room temperature to fall below 0°C. Before positioning, take the machine out of its packaging by following the warnings located on the package. Position the machine close to a water tap or drain. You need to site your machine, taking into consideration that its connections will not be altered once they are made. Do not grip the machine by its door or panel in order to move it.
Water inlet hose Do not use the water inlet hose of your old machine,if any. Use the new water inlet hose supplied with your machine instead. If you are going to connect a new or long - unused water inlet hose to your machine ,run water through it for a while before making the connection. Connect the water inlet hose directly to the water inlet tap. The pressure supplied by the tap should be at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa.
Water outlet hose The water drain hose can be connected either directly to the water drain hole or to the sink outlet spigot. Using a special bent pipe (if available), the water can be drained directly into the sink via hooking the bent pipe over the edge of the sink. This connection should be at a minimum of 50 cm and at a maximum of 110 cm from the floor plane. Warning: When a drain hose longer than 4 m is used, the dishes might remain dirty. In that case, our company will not accept responsibility.
Electrical connection The earthed plug of your machine should be connected to an earthed outlet supplied by suitable voltage and current. If there is no earthing installation, have a competent electrician carry out an earthing installation. In case of usage without earthing installed, our company will not be responsible for any loss of usage that might occur. The indoor fuse current value should be 10-16 A. Your machine is set according to 220-240 V. The machine should not be plugged in during positioning.
Fitting the machine undercounter If you wish to fit your machine undercounter, check whether you have sufficient space under your countertop and whether the wiring-plumbing is suitable to do so.1 If you decide that the space under the countertop is suitable for fitting your machine, remove the worktop as shown in the illustration. 2 If the appliance is installed on a carpet floor, take care that the openings in its base are not obstructed.
Adjust the machine feet according to the slope of the floor.3 Fit your machine by pushing it undercounter without letting the hoses get crushed or bent.4 H Height Without Insulation All Product 820 mm Product With Insulation For 2nd Basket For 3rd Basket 830mm 835 mm Warning: After removal of worktop, the machine should be placed in such a closed place of which dimensions are shown at fig.
PREPARING THE MACHINE FOR USE Prior to using the machine for the first time • Check whether the electricity and supply water specifications match the values indicated by the installation instructions for the machine. • Remove all packaging materials inside the machine. • Fill the rinse aid compartment. Warning: Some dishwasher detergents are strongly alkaline. They can be extremely dangerous if swallowed. Avoid contact with skin and eyes and keep children away from the dishwasher when the door is open.
• • • • • Observe the instructions on packagings when using such products. If such detergents are in the form of tablets, never put them into the interior section or the cutlery basket of the dishwasher. Always put the tablets into the detergent compartment in the detergent dispenser. They produce good results for certain types of usage only. If you are using this type of detergents, you need to contact the manufacturers and find out about the suitable conditions of use.
Warning: Use only those rinse aid materials which are allowed for use in the machine. As rinse aid residues left as a result of overflowing will create extremely high amounts of foam and thus reduce the washing performance, remove the excess amount of rinse aid by wiping it with a rag. LOADING YOUR DISHWASHER If you properly place your dishes into the machine, you will be using it in the best way in terms of energy consumption, washing and drying performance.
Top basket height adjustment while it is full Basket height adjustment mechanism on the top basket of your machine is designed to let you adjust the height of your top basket upwards or downwards, without removing it from your machine when it is full, and create large spaces at the top or bottom area of your machine as needed. Basket of your machine is set to upper position in factory settings. In order to raise your basket, hold it from both sides and pull it upwards.
Upper Cutlery Basket The upper cutlery basket is designed for you to place forks, spoons and knives, long dippers and small items. Because it can easily be taken out of the machine, it allows your dishes to be taken out of the machine along with the basket after washing. The Upper Cutlery Basket is composed of two pieces; if you need to make space for the dishes in the upper basket, you can take out the left or right part of the upper cutlery basket in order to obtain more space. .
Lower Basket Folding Racks Folding racks consisting of four parts that are located on the lower basket of your machine are designed in order to let you place big items easier such as pots, pans, etc. If requested, each part can be folded separately, or all of them can be folded and larger spaces can be obtained. You can use folding racks by raising them upwards, or by folding.
Alternative basket loads Lower Basket Top basket 22
Faulty loads 23
PROGRAM DESCRIPTIONS Program items Name of Program Prewash Quick 30 min. Economic 50°C Super 50 min.
GETTING FAMILIAR WITH YOUR MACHINE 1 2 3 9 10 11 4 5 6 7 1.) ON/OFF Button When one presses the on/off button, the machine is energized and the light on Start/Standby button goes on. 8 3 2.) Extra Rinse / Dry Button You can add extra rinsing or drying functions into the selected program by using extra button.
Thus, washing up shall be done only on the lower basket of your machine. In using this feature,make sure that there are no dishes in the upper basket. Note : If you have used an extra feature on the latest washing program, this feature will remain active also on the next washing program. If you do not want to use this feature on the newly selected washing program, press the selected feature button again, and check that the lamp on the button goes off. 6.
SWITCHING ON THE MACHINE AND SELECTING A PROGRAMME Switching on the machine The lamp on Program Start/Pause key goes off once the Program starts and the washing lamp is highlighted. 1. Press the Power On/Off key. 2. Select the program suiting your dishes via the Program Selector button. 3. If you prefer you can choose Once the Power On/Off key is pressed, the lamp Power Start/Pause is highlighted. additional function. 4 Start the program pressing 4. the Power Start/Pause key.
Changing a programme with resetting If you would like to cancel a program while a washing program is resumed. Hold Start/Pause button pressed for approx. 3 sec. until Finish light blinks. Once Finish light comes on, it means that the cycle has been cancelled. After Finish light starts blinking, discharges the water inside for approx. 30sec. Switching the machine off Pull the plug out of the outlet. Turn of the water tap.
MAINTENANCE AND CLEANING Cleaning the machine in regular intervals prolongs the machine’s service life. Oil and lime may accumulate in the machine’s washing section. In case of such accumulation; -Fill the detergent compartment without loading any dishes into the machine, select a programme that runs at high temperature, and start the machine. In case of insufficiency, use special cleansing material available in the market. (Cleansing material produced special to machines by detergent producers.
Spray arms Check whether or not the holes for the upper and lower spray arms are clogged. If there is any clogging, remove the spray arms and clean them under water. You can remove the lower spray arm by pulling it upwards, while the upper spray arm nut can be removed by turning the nut to the left. Be sure that the nut is perfectly tightened when refitting the upper spray arm.
31 F6 F9 F7 FE F1 F8 F2 F3 F5 ERROR CODE If the error continues, contact the service person. Power off-on your machine and activate the program cancellation command. The filters of your machine might be clogged. Water discharge hose is clogged. Contact the service person. Close the tap. Restart your machine, contact the service person if the error resumes. Close the water input tap, separate the water input hose from the tap and clean the filter at the connection end of the hose.
If one of program monitor lights is on and start/Pause light is on and off, Your machine’s door is open, shut the door. If the programme won’t start • Check if the plug is connected. • Check your indoor fuses. • Be sure that the water inlet tap is turned on. • Be sure that you have closed the machine door. • Be sure that you switched off the machine by pressing the Power On / Off button. • Be sure that the water inlet filter and the machine filters are not clogged.
If the dishes won't dry up • A programme without a dry operation selected. • Rinse aid dosage set too low • Dishes unloaded too fast. If there are rust stains on the dishes • Stainless-steel quality of the dishes washed is insufficient. • Unhealthy mains grounding. Call an authorised service if the problem still persists after the controls or in case of any malfunction not described above. PRACTICAL AND USEFUL INFORMATION 1.
AUSTRALIAN & NEW ZEALAND PRODUCT WARRANTY STATEMENT OF STANDARD WARRANTY CONDITIONS AUSTRALIAN CUSTOMERS Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
52165370 R20-0