User Manual

 USEANDMAINTENANCE
•Itisrecommendedtooperatetheappliancepriortocooking.Itisrecommendedtoleavetheappliancein
operation for 15 minutes after cooking is terminated in order to help eliminate cooking vapors and odors. The
proper function of the rangehood is conditioned by the regularity of the maintenance operations, in particular,
the active carbon lter.
•Theanti-greaselterscapturethegreaseparticlessuspendedintheair,andarethereforesubjecttoclogging
according to the frequency of the use of the appliance. In order to prevent re hazard, it is recommended to
clean the lter at a maximum of 2 months by carrying out the following instructions:
- Remove the anti-grease lters from the rangehood and wash them in a solution of water and neutral liquid
detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The anti-grease lters may also be washed in the dishwasher. The aluminum panels may alter in colour after
several washes. This is not cause for customer complaint nor replacement of panels.
•Theactivecarbonltershelptopurifytheairthatisreplacedintheenvironment.Theltersarenotwashable
nor reusable and must be replaced at maximum every four months. The saturation of the active carbon lter
depends on the frequency of use of the appliance, by the type of cooking and the regularity of cleaning the
anti-grease lters.
•Cleanthefanandothersurfacesoftherangehoodregularlyusingaclothmoistenedwithdenaturedalcohol
or non abrasive liquid detergent.
•Thelightfunction isdesignedforuseduringcooking and notforprolongedgeneralilluminationofthe
environment. Prolonged use will notably reduce the duration of the bulb.
•ReplacingLEDlamps(Fig.8):
Replacement of the LED lamps needs to be carried out by an authorised technician. Please contact an authorised
service centre when this needs to be arranged.
•  Commands (Fig.9) luminous the key symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D= SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
•  To operate the INTENSIVE speed function, press key E for two seconds and it will be activated for 10 minutes
after which it will return to the previously set speed. When the function is active the LED ashes. To interrupt it
before the 10 minutes have expired press key E again.
•  By pressing key F for two seconds (with the rangehood switched o) the "clean air" function is activated.
This function switches the appliance on for ten minutes every hour at speed level 1. As soon as this function is
activated the motor starts up at speed level 1 for ten minutes, During this time key F and key C will ash at the
same time.
After ten minutes the motor switches o and the LED of key F remains switched on with a xed light until the
motor starts up again at speed level 1 after fty minutes. Keys F and C start to ash again for ten minutes and so on.
By pressing any key (excluding the rangehood light key A) the "clean air" function will be deactivated and the
rangehood will return to normal operation (e.g. if key D is pressed the "clean air" function is deactivated and
the motor moves to the 2nd speed straight away. By pressing key B the function is deactivated).
(*) The "AUTOMATIC STOP TIMER" delays stopping of the rangehood, which will continue functioning for 15
minutes at the operating speed set at the time this function is activated.
•Activecarbon/greaseltersaturation:
- When button A ashes at a frequency of 2 seconds, the grease lters must be cleaned.
- When button A ashes at a frequency of 0.5 seconds, the carbon lters must be replaced.
After the lter has been replaced, the electronic memory must be reset by pressing button A for approximately
5 seconds, until the light on the button stops ashing.
THEMANUFACTURERDECLINESALLRESPONSIBILITYFOREVENTUALDAMAGESCAUSEDBYBREACHING
THE WARNINGS SET OUT IN THIS MANUAL.
- 9 -