Instruction Manual

49
english
11. Removing and replacing the bolt assembly
WARNING:
G Before performing any cleaning or
maintenance, make sure there are no
cartridges in the chamber or magazine.
11.1 Removing the bolt assembly
• Unload the rifle (see chapter 10).
• Remove the magazine.
• Pull the bolt assembly all the way back.
• Push down and hold the bolt stop pin
(fig. 12) and simultaneously withdraw
the bolt assembly backwards with the
other hand.
11.2 Installing the bolt assembly
• Carefully position the ends of the two
slide rails onto the rear end of the
receiver in line with the bolt guide.
• slide the bolt assembly forward into
the receiver.
• Close the bolt by pushing the bolt
handle forward.
NOTE:
Do not use force when doing this!
If the bolt assembly does not slide on
smoothly, try again taking more care.
fig. 12